IBM C4040-121

全額返却保証

もしお客様は本社のVirtualization Technical Support for IBM i -v1学習資料を使用した後、一回目にVirtualization Technical Support for IBM i -v1試験に通過しないなら、本社はVirtualization Technical Support for IBM i -v1学習資料を購入したお金を返金します。お客様は失敗したVirtualization Technical Support for IBM i -v1試験成績書をメールで送信します。そして、わが社の係員はその試験成績書をチェックした後で、あなたの返金要求に応じて100％返金を保証します。

C4040-121試験問題集をすぐにダウンロード：成功に支払ってから、我々のシステムは自動的にメールであなたの購入した商品をあなたのメールアドレスにお送りいたします。（12時間以内で届かないなら、我々を連絡してください。Note：ゴミ箱の検査を忘れないでください。）

本社のVirtualization Technical Support for IBM i -v1問題対策を購入すると、五分から十分までの時間にお客様のメールアドレスにお届けします。Virtualization Technical Support for IBM i -v1勉強資料を受け取る際に、すぐにダウンロードして使用できます。使用中にVirtualization Technical Support for IBM i -v1試験勉強資料についてどんな疑問がある場合に、本社の係員に連絡してください。この問題に対して、弊社の社員はすぐに対応します。

我々社はVirtualization Technical Support for IBM i -v1勉強資料をリリースされる以来、たくさんの好評を博しました。試験に合格したお客様は「C4040-121オンラインテストエンジンを利用して、模擬試験を繰り返して受けました。無事試験に合格しました。大変助かりました。」と感謝します。あなたの支持こそ我々は最も高品質のVirtualization Technical Support for IBM i -v1問題集を開発して努力します。

一年間無料の更新サービス

お客様はいつでもVirtualization Technical Support for IBM i -v1最新な勉強資料を獲得するために、我々社は常に更新の情況を確認します。だから、我々のVirtualization Technical Support for IBM i -v1試験勉強資料は試験問題の変化に伴って、更新しつつあります。購入日から一年間に、このような更新サービスをお客様たちに無料で提供しますので、ご安心ください。

IBM Virtualization Technical Support for IBM i -v1 認定 C4040-121 試験問題:

1. What is the minimum required configuration in a client LPAR to virtualize disk storage from a host IBM i LPAR to the client IBM i LPAR?

A) One NWSD and one vSCSI client adapter
B) One vSCSI client adapter and one NWSSTG
C) One vSCSI client adapter
D) One network storage description

2. A customer has purchased a new BladeCenter H (BCH) and POWER blade to run IBM i. The POWER blade is configured with two Fibre Channel interlaces for attaching SAN and tape.
They have an IBM TS3500 tape library with a fibre channel connection, and current firmware is running through a fibre switch to another IBM i system. One port on the existing switch and one port in the BCH fibre switch has been zoned to provide a connection from the tape library to the BCH.
After IBM i 7.1 SLIC and base OS are installed on the blade from IBM distribution media, the tape library does not appear in the device configuration.
What is the most likely cause of the problem?

A) The existing switch does not support NPIV.
B) A switch-to-switch cable is required. A switch to device cable was shipped with the BCH by default.
C) The BCH switch configuration must match the link speed of the TS3500.
D) NPIV enablement was omitted when configuring the BCH switch.

3. What boot mode is required when installing a hosted AIX or Linux partition?

A) System Management Services (SMS)
B) Open Firmware OK prompt (OPEN_FIRMWARE)
C) Diagnostic with default boot list (DIAG_DEFAULT)
D) Diagnostic with stored boot list (DIAG_STORED)

4. A POWER7 server is being configured with 1 hosting IBM i partition and 4 client IBM i partitions. All partitions will run IBM i 7.1, TR4. The hosting partition is providing network support to the client partitions and needs both redundancy and best bandwidth.
What connectivity on the host partition will support these requirements?

A) Using two or more physical Ethernet resources configure an aggregated link to the switch and use this for the bridge to the internal vLANs used by the client partitions.
B) Configure two or more Ethernet lines. Create a Virtual IP address for the host partition. Configure Showler routes to the local network for load balancing.
C) Using two or more physical Ethernet resources configure an aggregated link to the switch and use this for IP address of the host partition.
D) Configure two or more Ethernet lines. Use the lines to create redundant bridges to the internal vLANs used by the client partitions.

5. A customer needs to replace a failed tape controller card on a running partition. The service action Serviceability-> Hardware -> Exchange ERU has been started. The card has been selected and the service action has been launched.
The message "The requested service action cannot currently be completed from this management console" is displayed.
What is the most likely reason for this error?

A) The tape device associated with the adapter is notvaried off.
B) The adapter has not been deallocated from the partition.
C) The partition is controlled by another HMC in the environment.
D) The service domain for the partition is still active.

質問と回答：